di gianfranco conti - 20021 Bollate (MI) ITALY - Viale Lombardia, 18 - Telefono (02) 38302386 r.a. - Telefax (02) 38302389
Rev. 0/96
ENGLISH
Pag. 7 di 9
7 - DIAGNOSTICS
VAVA
Should the machine stop functioning, check the fuse in the rear feed connection group. For replace-
ment of same, utilize a fuse according to the material list attached to the diagram.
To reach the fuse group, it is necessary to insulate the machine from electric mains.
A small box can be found in the lower part of the group, in which the connected fuse is contained,
together with the spare fuse.
By using the tang, it is possible to open the box, removing the most internal fuse and replacing it
with the spare one.
Assure that the switch is on 0 position (OFF).
Having re-closed the box, it is possible to connect the feed cable again.
In case of incorrect functioning and/or damages/breakdowns, immediately pull out the plug and put
the general switch on the OFF position.
The machine is equipped with a thermostat where normal functioning is interrupted should break-
downs or malfunctions generate an excessive temperature with respect to that established by manu-
facturer. In above circumstances, the machine should be isolated, and the technical service should
then be contacted for any eventual interventions.
VISPA and VISPA-UP
Should the machine be out of operation, check the fuse in the rear area of the appliance.
For the replacement of same utilize a fuse according to the material list attached to the diagram.
To reach the fuse group, it is necessary to insulate the machine from electric mains.
Assure that the switch is on position 0 (OFF).
Unscrew the cap and extract fuse, replacing it with a spare one.
Once cap has been screwed back on, it is possible to connect up to the mains again.
In the case of incorrect functioning and/or damages/breakdowns, immediately pull out the plug and
put the general switch on the OFF position.
The machine is equipped with a thermostat where normal functioning is interrupted should break-
downs or malfunctions generate an excessive temperature with respect to that established by manu-
facturer. In above circumstances, the machine should be isolated, and the technical service should
then be contacted for any eventual interventions.
ATTENTION!
ANY INTERVENTION ON THE MACHINE MUST BE
REALIZED WITH THE ELECTRICITY TURNED OFF
