TRANSFER
Transmitter N°1
Replace
Transmitter
Master Nº 1
TRANSMITTER REPLACEMENT
US: 001 RL: ½ KY: A
STORE USER ?
US: 001 RL: ½ KY: A
REPLACE ?
EXECUTED OK
USER Nº 001
back to the welcome message
EXECUTED OK
ANOTHER ...
1b) With a service receiver but without backup
memory
If the site backup memory is not available
know the access code of the site receiver and the memory
positions available for the transmitters.
- Replace the service receiver password with the one the
access code with that of the receiver installed on site.
- Proceed to the memorization of the transmitter or
transmitters to be added (see "Memorize one or more
supplementary transmitters" p. 20).
- Transfer the data to the transmitter or tansmitters by
following the diagram below using the Rx-Tx cable (fig.
14).
Once transfer is complete, the transmitter is ready to be
memorized on site.
, it is necessary to
Transmitter
Master
Automatic
Exit
Automatic
Automatic
PROG TRANSMITTER
CONNECTED ?
US: 001 RL: 2 KY: D
EXECUTED OK
PROG TRANSMITTER
VERIFY ....
Transfer OK
US: 001 RL: 2 KY: D
PROG. ERROR
Transfer problem
PROG. TRANSMITTER
DISABLED
This transmitter isn’t
memorized in the receiver
Pag. 23
WARNING: After transfer, only the first 16
activations of the transmitter key will allow the
memorization of the receiver installed on site.
2
Memorization of the transmitter on site.
The transmitter has been preset but it will only be
memorized in the receiver installed on site after the
following operation:
- on site, press simultaneously the two buttons A and B
of the transmitter (fig. 15), release them and then press
button B.
After releasing it the transmitter will be memorized.
NO+
YES
YES
YES
NO+
YES
NO
NO+
YES
Substitute
Transmitter N°1
Replace
Transmitter N°1
Replace
Transmitter N°1
Replace
Transmitter N°1
Replace
Transmitter N°1
