Slimdrive SL-RD
4
Chapter 3.10
1
Rubber cord
2
Outer roller carriage
3
Cord fixture mounted on the left leaf
4
Cord deflection
5
Running rail buffer
6
Inner roller carriage
7
Cord fixture in the running rail
8
Knot
L
Length of the relaxed rubber cord
X
Place the rubber cord (1) around the cord deflection (4) and fit the cord deflection in the runner rail.
X
Fit the inner roller carriage (6) in such a way that both ends of the rubber cord run past it.
X
Make sure that the rubber cords do not twist.
X
Fit the outer roller carriage (2) in such a way only the rear rubber cord runs past it.
The front rubber cord hangs out between the two roller carriages of a leaf.
X
Install running rail buffer (5).
X
Knot the rubber cord at the cord fixture (7) and install the cord fixture (7) in the running rail.
X
Make sure enough rubber cord is left protruding.
X
Knot the rubber cord tightly on the cord attachment bracket of the cord fixture (7) and trim as close to the
knot as possible.
X
Install leaf.
X
Make sure that the rubber cord which is protruding between the roller carriages hangs down in front of the
leaf.
X
Insert the cord fixture (3) in the running rail and screw tightly to the plate provided on the leaf.
X
Pre-tension the rubber cord on the cord attachment and knot it.
The rubber cord has been pre-tensioned correctly when the relaxed protruding part (length L) is in accordance
with the following lengths:
à
for light doors (< ca. 60 kg): Opening width ÖW / 2
à
for heavy doors: 0.7 × opening width ÖW
X
When mounting the leaves, check again that the cord is routed as illustrated above.
