9
Programming
The IR receiver can be programmed with GewaLink channels 0-127 (channel 62 has no
function) or one coded channel (4096). There is one programming button for each relay. The
selection is also made during programming whether a particular relay is to function in a
monostable or a bistable manner.
Monostable functioning = The relay is activated as long as the key on the IR transmitter is
held down.
Bistable functioning = The relay is activated when the key on the IR transmitter is held down
and releases. The second time the key is held down and released, the relay will be deactivated.
Warning! Gewa AB advise against using bistable control of the window opener as there is a
risk of entrapment of fingers, limbs etc.
Program the receiver as follows:
Press the selected button on the IR transmitter and press at the same time one of the
programming buttons on the IR receiver. If the programming button is held down for
approximately 1 second, the unit is programmed with a monostable function. If it is held
down for approximately 2 seconds, the unit is programmed with a bistable function.
The receiver confirms the programming by activating the relay and causing the indicator lamp
to flash. Simply repeat the procedure if the selected channel or function is not satisfactory.
Warning! The relevant relay is activated during the programming. This may case an
inadvertent activation of some equipment.
Attaching the Lid
It is possible to fix the lid of the GL-4M model, with the included screws.
Cleaning
Dip a rag into water with a little washing-up liquid in it and wring it out well. This can then
be used to clean the outer casing of the receiver.
