GESTRA KH, Original Installation Instructions

Page: 12 / 16

12
➢ Remove all residues from the unit.
➢ For the disposal of all residues observe the
pertinent legal regulations concerning
waste disposal.
Removing the unit
DANGER
Personnel working on pipes are exposed
to safety risks and may suffer severe
injuries, poisoning or even loss of life.
➢ Make sure that no hot or hazardous
fluid is in the unit or the pipes.
➢
Make sure that the pipes upstream
and downstream of the unit are
depressurised.
➢
Make sure that the installation is
switched off and protected against
unauthorised or unintended
activation.
➢ Make sure that the unit and the
pipes have cooled down to room
temperatures.
➢ Wear protective clothing that is
suitable for the fluid and, if
necessary, wear protective gear.
For more information on suitable safety clothing
and safety gear refer to the safety data sheet of
the fluid in question.
DANGER
Risk of bruises if the unit or component
parts fall down.
➢
Use suitable lifting gear when
moving or lifting the unit and/or
component parts.
➢
Make sure that the unit cannot
topple over.
➢ Make sure that nobody is standing
below the lifted unit.
➢
Store the unit as described in section
“ Storing the unit “ .
Re-using unit after storage
Observe the following instructions if you want to
remove the unit and use it again somewhere
else:
➢
Make sure that the unit is free of any fluid
residues.
➢ Make sure that all connections are in good
condition and leak-free.
➢ Use the unit only for its intended purpose
and the service conditions for which it was
specified.
Disposing of the unit
CAUTION
Environmental damage may be caused
by poisonous fluid residues.
➢ Before disposing of the unit make
sure that it is clean and free of fluid
residues.
➢ For the disposal of all materials
observe the pertinent legal
regulations concerning waste
disposal.
The unit is made of welded sheet steel.