Gesipa TAUREX 1 Axial, Operating Instructions Manual

Page: 21 / 160

21
GB
12. Warranty
The applicable terms and conditions of guarantee shall apply and can be viewed under follow -
ing link: www.gesipa.com/agb
10. Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by
skilled technical personnel . Failure to observe the as-
sembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the blind rivet setting tool. In case of doubt, always send the blind rivet setting tool
back to the supplier or to GESIPA
®
.
11. Troubleshooting
11.1 Blind rivet is not set
Cause Corrective measures
Jaws (E) dirty Clean and oil sliding surfaces (Point 9.1)
Jaws (E) worn Replace (Point 9.2)
Insufficient working pressure See working pressure (Point 5)
Tool stroke too low Top up with hydraulic oil (Point 9.3)
11.2 Spent mandrel is not evacuated
Cause Corrective measures
Spent mandrel container full Empty (Point 8.4)
Mandrel evacuation hose blocked Empty (Point 8.4)
Wrong nosepiece (A) used Replace according to table (Point 7)
Nosepiece (A) worn Replace
Spent mandrel jammed in jaws (E)
Clean jaws (E) and jaw housing (D) and oil sliding
surfaces; replace if worn (Point 9.2)