Gesipa TAUREX 1 Axial, Operating Instructions Manual

Page: 20 / 160

20
GB
9.4 Storage
The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
• Disconnect the riveting tool from the compressed air supply.
• Remove the hanger (I) from the riveting tool.
• Remove oil screw plug with seal (G and H) and screw the supplied oil refill reservoir into
the thread.
• Unscrew steel head sleeve (B) and push grip mechanism by hand as far as it will go into
the tool head.
• Hang up the tool head by the handle. Make sure that there are no loops in the hydraulic
hose, with a constant incline from the air cylinder to the tool head.
• Remove oil screw plug with seal (J and K) and screw supplied filling adapter into the
thread.
• Fit oil can with pump mechanism (not included in scope of delivery) into the free end of
the filling adapter hose.
• Pump hydraulic oil into the tool until the oil refill reservoir at the tool head is approximate -
ly half full.
• Lower the tool head to the same level as the air cylinder and remove the oil refill reser -
voir. Screw in the oil screw plug together with seal (G and H) and tighten.
• Unscrew filling adapter then screw in the oil screw plug together with seal (J and K) and
tighten.
• Connect riveting tool to compressed air supply.
• Carefully undo oil screw plug (G) by 2 turns; the grip mechanism moves slowly into the
front end position. Collect leaking oil in a rag.
• Tighten oil screw plug (G).
• Screw on steel head sleeve (B).
9.3 To top up hydraulic oil
Follow correct sequence!
Wear safety goggles! Danger of oil escaping at high pressure.
Regular maintenance will extend the service life of your high-quality GESIPA
®
tools
and they should be serviced at least every 2 years by an authorised workshop or by
GESIPA
®
Service. We recommend servicing tools that are subject to intensive use
ahead of schedule.