Gesipa AccuBird, Operating Manual With Spare Parts List

Page: 13 / 17

26
GB
3.5 Environmental protection
If batteries need to be replaced, please observe the following:
•
Return used GESIPA
®
rechargeable batteries to your dealer or to GESIPA
®
for recycling.
• 1HYHUGLVFDUGXVHGEDWWHULHVLQWRKRXVHKROGZDVWH¿UHRULQWRZDWHU
Caution!
In all EU countries (except Germany) the relevant national regulations for implementing
the EU guideline shall apply.
• In accordance with the EU Directive 2002/96/EC (WEEE), in Germany, this tool is
registered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial num-
ber it can be returned free of charge to GESIPA
®
for correct disposal.
4. Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the riveting tool. In case of doubt, always send the riveting tool back to the supplier
or to GESIPA
®
.
Charging times
Battery type Part No. Charging time*
1.3 Ah 143 4921 approx. 50 min
2.6 Ah 145 7269 approx. 100 min.
*
Charging times may vary depending on the residual capacity and the battery temperature.
3.4 Battery care
• To obtain an optimum charge, allow the battery to cool down before inserting it in the charger.
• The GESIPA ® battery can be recharged approx. 1000 times and reaches its full capacity after
several charges.
• Do not insert the battery into the charger after each use.
• Only charge the battery when it is discharged and rivets can no longer be set. Only recharge
the battery after a prolonged idle period.
• 6LJQL¿FDQWO\VKRUWHUEDWWHU\RSHUDWLQJWLPHVGHVSLWHSURSHUUHFKDUJLQJLQGLFDWHWKDWWKH
battery needs to be replaced.
• Store batteries in a dry place where there is no danger of frost. The optimum operating tem-
perature range is 10°C to max. 50°C.