23
GB
2.7
Start-Up
Before starting the riveting tool, read and observe the operating instructions and safety
information and keep in a safe place.
•
Insert fully charged battery in correct position into riveting tool.
•
Select nosepiece from Table 2.6 and screw on.
Caution!
7KHDLULQOHWVIRUWKHPRWRUVKRXOGQRWEHREVWUXFWHGGRQRWLQVHUWDQ\REMHFWV
into them.
BT = BULB-TITE
®
MG = MEGA GRIP
®
* available as special accessory. Elongated nosepieces and other special nosepieces are
available on request.
** also available as conversion kit Part No. 143 5033.
2.7.1 To attach spent mandrel container
a. Pressing and holding the switch:
Press and hold the switch to start riveting. The pulling process stops automatically when the
rivet reaches the rear end position. The tool automatically assumes the front starting position
when the switch is released.
•
Fully screw on spent mandrel container (H) by turning clockwise.
2.7.2 To set a blind rivet
b. Tapping the switch:
5LYHWLQJLVWULJJHUHGE\EULHÀ\WDSSLQJDQGLPPHGLDWHO\UHOHDVLQJWKHVZLWFK$VVRRQDVWKH
mandrel breaks off, the blind riveting tool stops and automatically re-assumes the front start-
ing position.
2.8
Maintenance
Maintenance of the riveting tool is limited to the complete jaw mechanism and its
wearing parts:
•
Detach battery from riveting tool.
•
Unscrew steel head sleeve (B) with WAF 27 open-ended spanner and clean.
Check for deposits in the tip of the steel head sleeve (B).
•
Use WAF 17 open-ended spanner to release jaw housing (C) from adapter.
•
Remove jaws (D), clean and oil sliding surfaces; replace if worn.
•
Re-assemble in reverse order ensuring that all parts are tightened!
Summary of Contents for AccuBird
Page 2: ...4 A B C D E F G H 1...
Page 3: ...5 AccuBird PowerBird...
