78
© GES Electronic & Service GmbH www.ges-electronic.de
Series
MC
S
Series
Part as delivered
cap (1), clamping rubber (2), outer cone (3), inner
cone (4), contacts (5), insulation part (6), housing (7)
Place inner cone (4) on cable
Place cap (1), clamping rubber (2) and outer
cone (3) on cable
Respect correct order of parts (see picture).
Remove dielectric insulation of single wires
(L2 = 4 mm [.157"])
Do not damage conductor.
Carefully remove cable jacket
(L1 = 28 mm [1.102"])
Do not damage metal shield.
Do not damage dielectric insulation.
Crimp or solder one contact (5) each on every conductor
Tin-solder must not remain on contact surface!
Fold back shield braid over jacket
Completely widen shield braid. Push outer cone (3)
and clamping rubber (2) under shield braid against
inner cone (4) until shield braid clamps between outer
cone (3) and inner cone (4)
Remove any filling elements from cable
Cut overlapping shield braid
Carefully remove loose shield parts. Loose shield
parts can cause electrical break down.
1.
6.
2.
7.
3.
8.
4.
9.
5.
10.
!
!
!
!
!
Assembly instructions (KB/KS)
