Gerni poseidon 2, User Manual

Page: 14 / 24

14
hose in a tank or bucket. To
avoid water spillage, crimp
the water inlet hose down in
the water and then connect
the hose to the machine with
the quick coupling and fi nally
uncrimp the water inlet hose.
2. Dismount spray handle,
lance and nozzle.
3. Turn the start/stop switch to
position " I " and let the water
run, until the air has escaped
from the water hose and the
pump.
4. Mount spray handle and
thereafter lance.
5.6 Start the machine (when
connected to open con-
tainers (suction mode))
The washer can take in water
from a rain water tank as an
example. The hose for the water
supply must not be too long,
approx. 5 m.
Make sure that the water tank is
not placed on a lower level than
the machine.
Use an external fi lter if the wa-
ter contains impurities.
1. Make sure that the water
hose is fi lled completely with
water before connecting to
the machine. Place the entire
High pressure
Low pressure/
detergents
5.7 Pressure regulation on
the Flexopower Plus-
spray lance
The pressure can be regulated
on the Flexopower Plus spray
lance.
3. Shut off the water supply and
activate the trigger to relieve
the machine of pressure.
4. Lock the spray handle.
When releasing the trigger of
the spray handle, the machine
automatically stops. The ma-
chine will start again when you
re-activate the spray handle.
5.8 Operation with
detergents
Application of detergents is
NOT possible if an extension
hose is applied.
1. Fill the container with a de-
tergent.
2. Mount the Flexopower Plus
spray lance and adjust it to
low pressure (see section
5.7).
3. Adjust the dosing regulator
(11) to the re quired vol ume
of detergent (0-5%).
4. Apply the detergent from
below and up wards.
5. Let the detergent act for the
time stated on the packing of
the detergent and fl ush with
pure water.
External detergent container
1. Remove the cover with suc-
tion hose from the detergent
container.
2. Mount the cover with suction
hose on the external deter-
gent container.