German pool SAC-109, User Manual

Page: 24 / 64

P.24
Mounting plate
Screw
Wiring diagram on
the back of the cover
Remove the
upper cover
Covered by insulating material
Condensed water
drain pipe
Refrigerant pipe
Refrigerant
pipe
Connection
cable
Connection
cable 1
(for heat-
pump)
Probe cable
(for heat-
pump)
Insulation sleeve
After having connected the pipe according to the
instructions, install the connection cables and drain pipe.
After connection, lag the pipe, cables and drain pipe
with insulating materials.
1. Arrange the pipes, cables and drain hose well.
2. Lag the pipe joints with insulating material, and secure
them it with vinyl tape.
3. Run the bound pipe, cables and drain pipe through
the wall hole and mount the indoor unit onto the
upper part of the mounting plate securely.
4. Press and push the lower part of the indoor unit
tightly against the mounting plate
Installation of the Outdoor Unit
- The outdoor unit should be installed on a solid wall
and fastened securely.
- The following procedure must be observed before
connecting the pipes and connecting cables: decide
on the best spot on the wall for installation as to
leave enough space for carrying out maintenance.
- Fasten the support to the wall using screw anchors
which are particularly suited to the type of wall.
- Use a large quantity of screw anchors than normally
required to bear the weight of the outdoor unit and
withstand vibration during operation. The outdoor unit
should be able to remain securely fastened for years.
- The unit must be installed following the national
regulations.
Electrical Connections
1. Take off the cover.
2. Connect the cable wires to the corresponding
terminal board using the same numbering marked
on the indoor unit.
3. For the electrical connections, see the wiring diagram
on the back of the cover.
4. Secure the cables with a cable-clamp.
5. An efficient earth connection must be ensured.
6. Replace the cover.
Installation Instructions
Installation of the Indoor Unit