German pool EVA-287, User Manual

Page: 6 / 33

P.11 P.10
Electrical Connections
• Installation place of the product must have appropriate electrical installation.
• Network voltage must be compatible with the values provided on type label of product.
• Product connection must be made in accordance with local and national electrical requirements.
• Before installing disconnect power source. Do not connect the product to a power source until its
installation is complete.
Electrical Safety
1. Plug the appliance into a grounded socket protected by a fuse conforming to the values specified in
the technical specifications chart.
2. Have an authorized electrician set grounding equipment. Our company shall not be responsible for
the damages that shall be incurred due to using the product without grounding according to local
regulations.
3. The circuit breaker switches of the oven shall be placed so that end user can reach them when the
oven is installed.
4. The power supply cord (the cord with plug) should not be in contact the hot parts of the appliance.
5. If the power supply cord (the cord with plug) is damaged, this cord shall be replaced by the
manufacturer or its service agent or an equally qualified personnel to prevent a hazardous situation.
6. Never wash the appliance by spraying or pouring water on it. There is a risk of electrocution.
7. WARNING: To avoid electric shock, ensure that the device circuit is open before changing the lamp.
8. WARNING: Cut off all supply circuit connections before accessing the terminals.
9. Do not use cut or damaged cords or extension cords.
10. Make sure that there is no liquid or humidity in the outlet where the product plug is installed.
11. The rear surface of the oven also heats up when the oven is operated. Electrical connections shall not
touch the rear surface, otherwise the connections may be damaged.
12. Do not tighten the connecting cables to the oven door and do not run them over hot surfaces. If the
cord melts, this may cause the oven to short circuit and even a fire.
13. Unplug the unit during installation, maintenance, cleaning and repair.
14.
Make sure the plug is inserted firmly into wall socket to avoid sparks.
15. Do not use steam cleaners for cleaning the appliance, otherwise electric shock may occur.
16. An Omni polar switch capable to disconnect power supply is required for installation. Disconnection
from power supply shall be provided with a switch or an integrated fuse installed on fixed power supply
according to the building code.
Electrical Connections
Electrical Connection
1. This oven must be installed and connected to its place correctly according to manufacturer
instructions and by an authorized service.
2. Appliance must be installed in an oven enclosure providing high ventilation.
3. Electrical connections of the appliance must be made only via sockets having earth system
furnished in compliance with rules. Contact an authorized electrician if there is no socket
complying with the earthed system at where appliance will be placed. Manufacturing company
is by no means responsible for damage resulting from connection of non-earthed sockets to
appliance.
4. Plug of your oven must be earthed; ensure that socket for the plug is earthed. Plug must be
located in a place that can be accessed after installation.
5. Your oven has been manufactured as 220V-240V~ 50Hz. AC power supply compliant and
requires a 13 Amp fuse. If your power network is different that these indicated values, refer to
an electrician or your authorized service.
6. When you need to replace the electrical fuse, please ensure that electrical connection is made
as follows:
- Phase brown cable to live terminal
- Blue cable to neutral terminal
- Yellow-green cable to earth terminal
7. Oven disconnecting switches must be in an accessible place for final user while oven is in its
place.
8. Power supply cable (plug in cable) must not touch hot parts of the appliance.