Page 9 of 9
5
You will need to go under the machine and remove the four screws (5mm) from the motor cover on
the y-axis motor housing with a 5mm Allen wrench. (The beam will be at the front of table so it will
require someone to crawl under the machine.) When under the table, loosen the clamp screw (2.5mm)
on the motor pulley.
6
Manually rotate the pulley belt so the beam moves the pen over the original registration mark.
Tighten the motor pulley clamp. Do not align the slot in the motor pulley clamp with the slots in the
motor pulley.
7
Turn off the router, and then perform Steps 2-6 until the Y orientation is correct. You may have to do
this several times to get the correct position.
