Page 8 of 9
Installing the front cover
To install the front cover
1
Rotate the center ball valve back towards the front of the router. Install the four ball valve mounting
bolts (6mm) on the center ball valve.
2
Support the front panel while you install the four screws (3mm) attaching the T-Vac panel to the end
covers and install the two screws (2.5mm) attaching the T-Vac panel to the leg covers.
3
Install the T-Vac handles to the front of the router by popping them into place.
Verifying the encoder pulse position
To verify the encoder pulse position
1
Plug in and turn on the router.
2
Slew the beam to approximately 1" from the front of the table. Slew the carriage to approximately 1"
from the left side of the table.
3
Push the A key on the keypad to orient the router.
4
Once the Sabre has oriented without moving the beam place pen tool in Spindle. Lower pen tool to
tabletop and depress spring so pen will draw. Slew pen in X direction. If new pen mark is in same
place as original, encoder pulse is ok. If pen line is off in either direction of original pen line follow
steps below.
