Gerber P2C™ 600
User’s Manual
General Information
1-24
CAUTION
After setting the cutting depth and/or knife pressure, perform a
thorough visual check of the knife blade where it protrudes from the
knife holder. Test the new settings by performing a knife depth test on
a scrap of vinyl media.
DO NOT OPERATE THE CUTTER if the knife blade cuts through the media
backing, as this will seriously damage the knife and rubber cutting
strip.
CAUTION
For most vinyl cutting activities, the tip of the blade should be barely
visible at the bottom of the knife tool. If you can clearly see the blade
tip, you will probably need to readjust the cutting depth.
To prevent damage to the cutter, check the depth of the knife tip and
the quality of the cut whenever loading a different type of vinyl into
the cutter.
7.
To change the knife offset, proceed as follows:
•
Power up the cutter and load a piece of media (See 1.7).
•
Press the
key three times.
•
Press the
key.
•
The knife offset parameter is displayed. The offset can be set
anywhere from 0.00 to 1.00mm.
•
Click the
key to perform a knife offset test as illustrated below.
