35
F1
OPERATIONAL SETUP
Settings
System
Misc.
ENTER for Main Menu
F3
CURRENT SETTINGS
Speed
Force
Accel
Corners
ENTER for Main Menu
F1
F4
F2
In the example below, F3 has been pressed five times to increase the
tool force for the selected material by five clicks.
♦
Pressing either the F1 or F2 key moves the bar graph in the opposite
direction. The bar moves toward zero. (One square for each key press.)
♦
At zero, indicated by a single square in the center, the factory default
for the selected material type is restored and no force adjustment is
present.
♦
Continued pressing of the F1 or F2 key will extend the bar graph to the
left of zero. The factory default is reduced by the number of additional
squares shown on the display.
4
Press the ENTER key to accept the new setting, or press CANCEL to
discard any changes, and return to the Settings menu.
Note: Changes can be made while a job is running. In this menu, pressing
CANCEL cancels the changes. It does not cancel the job unless you press
CANCEL again.
To make specific numeric changes at the plotter control panel
1
Press F3 while holding down the ENTER key for the Operational
Setup menu.
2
Press F1, Settings, to get the Current Settings menu.
3
Press the F3 Force to see the current value for each setting.
ADJUST TOOL FORCE
- less 0
more +
. . . . . . . . . .
] ] ] ] ] ]
] ] ] ] ] ]
] ] ] ] ] ]
] ] ] ] ] ]
ENTER Key to Accept
F3
F4
F1
F2
Summary of Contents for ODYSSEY XP
Page 1: ...Owner s Guide ...
Page 4: ......
