10
CHAPTER 2
Getting Started
2
Push in and slide the material width adjustment handle to set the grit
wheels for the material width. If you set the width to the actual
material width, the scale provides a compensation so that the material
properly extends 1/2" (1.3 cm) beyond the center of the left grit wheel.
If necessary, slide the material over the platen and use it to measure
that the material extends properly beyond the center of the left grit
wheel.
3
Slide the pinch wheels directly above the grit wheels.
4
Set the controls on the middle pinch wheel as follows:
♦
If you are loading paper or drafting vellum, and it is wider than 25"
(64 cm), pivot the riser block up to prevent the center pinch wheel
from contacting the material.
♦
If you are loading narrow material (less than 25" (64 cm)), pivot the
Hi-Lo Force lever on the center pinch wheel assembly up. If you are
loading material wider than 25" (64 cm), pivot the Hi-Lo Force lever
down. Verify that the lever is in the correct position by looking at the
message display on the control panel.
5
Slide the material over the platen and under the pinch wheels.
6
From the front of the plotter, slide the material to the right so that the
right edge of the material is exactly aligned with the alignment mark
on the platen and the leading edge of the material is beyond the front
edge sensor. Make sure the material runs under both the front and
rear edge sensors and deflectors.
Force lever
in down
position
Riser block in
up position
Summary of Contents for ODYSSEY XP
Page 1: ...Owner s Guide ...
Page 4: ......
