- 4 -
HARDWARE RESET
1. Make sure the power from the receiver is turn -on. The indicating LED lights on.
2. Drive the motor to 0
°
via the manual button.
3. Probe the RESET button behind the bottom of the motor via a thin rod for 2 seconds. The LED
blinks in Orange Color. The reset process is OK while the LED is green. The preset Satelli te
Table will be re-install and the current position will be set as 0
°
. Please cut off the power for the
motor first before any operation.
DiSEqC 1.2 OPERATION
The Motor is designed for DiSEqC 1.2 Receiver. The commands on the receivers might be
different, but similar. Please refer to the manual of the receiver.
1. Go East / West: Drive the dish to East / West.
2. Fine Tune East / West: Drive the dish East / West for one step.
3. Store nn: Store Satellites Position nn (01~60).
4. Goto nn: Drive Motor to Satellite Position nn (01~60).
5. East / West Limits: Set software East / West limits.
6. Limit Off: Disable the software limits.
7. Goto 0
°
: Drive the Motor to 0
°
as a reference point.
8. Re-synchronize / Shift:
a) Drive the motor to a position by Goto command. For example,
P03
.
b) Drive the motor East / West to a better position.
c) Send Re-synchronize commands to the motor. The
P03
will be shifted to the new position.
All the other Satellite positions are also changed.
d) If step a) is skipped, the P01 will be shifted to the new position.
9. Goto X Function or USALS:
e) This function only works with receivers which have goto x function.
f) It can drive the motor to exact x.x
°
East or West relative to the 0 position of the motor.
( For example, 15.2
°
East on the bottom of the motor.)
g) Just input the longitude, some receivers can drive the antenna to focus on the right
Satellites automatically after locating and peaking the first satellite.
P03
P02
P01
P02
P03
P01
Stored Positions
http://www.geosatpro.com
