PM
9
:59
P
AM
4:27
50
12
•
The stopwatch enables you to measure an intermediate time (SPLIT: the time passed
since the start up to arrival at the given point). It does not allow you to save information in
memory.
•
Using the stopwatch
When the stopwatch has stopped, press the
SPLIT/RESET
button to reset to 0.
•
The stopwatch is started/stopped by pressing the
START/STOP
button (Time format:
minutes: seconds: 1/100 second). The maximum value is 23 h 59min 59s 99.
At the top of the screen, the dash for Friday (FR) will flash and indicate that the stopwatch
is functioning.
•
Several time measurements can be accumulated by pressing
START/STOP
again
between each measurement.
•
The intermediate time measurements can be displayed when the stopwatch is running
by pressing repeatedly on the
SPLIT/RESET
button. At the top of the screen, the dash for
Thursday (TH) will begin to flash, indicating that the stopwatch is in the "intermediate time"
position
Press
SPLIT/RESET
again to return to the normal stopwatch display.
3 Setting mode for the alarm
START/STOP:
to set the parameter that is flashing
SPLIT/RESET:
go to the settings mode for the
following parameter
MODE :
go to the following mode
•
When entering this mode, the alarm time is displayed and the number of hours flashes
to indicate that you have entered the setting mode.
Press
START/STOP
to set the hours
Press
SPLIT/RESET
to make the minutes flash
Press
START/STOP
to set the minutes
ATTENTION :
Depending on the time display mode (to be set in the next mode, following paragraph),
you will see an "H" to the right of the time (24h display) or an "A" or a "P" (12h display).
To change the alarm display, you must change the time display.
•
When entering the setting mode, the alarm is automatically activated. You must
invalidate it by using the procedure described in the time mode.
•
The modifications made to the alarm are automatically validated when you leave the
mode by the MODE button.
4 Time setting mode
START/STOP:
to set the parameter that is flashing
SPLIT/RESET:
go to the settings mode for the
following parameter
MODE :
go to the following mode
