21
Setting parameters :
Before anything else, you must enter your personal parameters so that the device
can provide you with the most personally accurate measurements possible..
After you have entered the heart rate monitor mode (PULS) by pressing successively
on the S3 button as indicated in paragraph 6.
Press for 3 seconds on S4, and the letters "zone Hr" will be displayed and the "on" light
will flash at the bottom of the screen.
Set the parameter flashing by pressing S1 (increase) or S2 (decrease). Hold the
button down for rapid scrolling.
After selecting the correct value, press S3 to go to the settings mode for the
following parameter.
The parameters that need to be set are the following :
•
Activation of the target zone (Zone Hr): possible values On, Off
•
Sex: man (Male), woman (Female)
•
Metric system or English system (unit): KG(kilograms) or LB(pounds)
•
Your weight (wt) in the units previously selected: from 20 to 300
•
Your age (age) (from 1 to 99 years)
•
The upper limit of the target zone (HI) (in beats per minute (BPM)
•
The lower limit of the target zone (LO)
•
Alarm for when the target zone is exceeded (zone ALM): possible values On/Off.
ATTENTION :
It is imperative that you check that this data is entered correctly before use in order
to ensure the reliable functioning of the heart rate monitor.
If the target zone function is deactivated
(zone Hr = OFF)
, there will be no sounding
alarm when you exceed the target zone and no display of the time spent in the
target zone in the reporting function of the stopwatch mode (see stopwatch mode).
If the
UNIT
parameter or the weight is changed, the stopwatch will be reset to 0
and the data erased.
To start using :
See
paragraph "Wearing the chest belt"
for positioning the belt.
Once everything is installed, bring the watch to within less than 50 cm of the belt
and then press
S1
to test the connection..
The heart on the display begins to flash and a value is displayed.
ATTENTION :
Disregard the values indicated before the device stabilizes (about 20 seconds). This is
the time necessary for the calculation algorithm to provide smooth, reliable numbers.
ATTENTION :
The pectoral belt does not have an encoded emitter; interference is to be expected
if you are located too close (about 1 meter) to other heart monitor wearers..
If the radio connection between the watch and the belt is interrupted for more than
1 minute, " --- " will be displayed on the middle line. To reactivate the connection,
press
S4
.
1013
mBar
60
22:01
ACC 70
M
69
8:00
ON
T1
AL-1
3.70
LAP
2.49
ALTI
ALTI
DATA 02
((
•
))
12:30
03
1013
T1
WE 4
P
mBar
60
22:01
ACC 70
M
69
8:00
T1
AL-1
ALTI
ALTI
DATA 02
12:30
03
1013
T1
WE 4
P
mBar
60
22:01
ACC 70
M
69
T1
AL-1
ALTI
ALTI
DATA 02
