GeoMax EZDig T, User Manual

Page: 34 / 36

Technical Information: Sensors
There are various reasons why the system isn’t able to detect a sensor. When you attach a sensor to a
sensor plate you’ll see a small green LED starting to blink on the sensor’s PCB, which indicates that it’s now
switched ON.
If - even though attached to the sensor plate - the sensor doesn’t switch ON:
-Remove the sensor from the sensor plate, wait min. 5 seconds and put it back on again.
-Check with another sensor plate.
-Put the sensor into sunlight or below a desk lamp. Try again after one hour.
If the sensor is ON (LED is blinking), but doesn’t communicate with the system:
-Remove the sensor from the sensor plate. Assign the missing sensor to the system by entering the “Add
Sensor” routine in the menu. Follow the instructions on the screen.
-Enter the sensor check menu through the Advanced Settings. If the angle value doesn’t flicker
continuously, but freezes shortly and comes back after a while, there are most likely radio disturbances:
-Try to relocate the LED display inside the cabin
-Try to relocate the cable inside the cabin if it moves along another electronic components
-Try to change the radio channel through the parameters inside the Advanced Settings menu
34