Geo Cruiser Owner’s Manual V1.3
Page 23
V. Battery Setup and Maintenance
Your Geo Cruiser is designed to use one (1) maintenance free 24V/10AH Lithium battery. The
Geo Cruiser comes with an easy use 24V/10mA charger. As stated earlier, the battery must be
fully charged before first time use.
• If the battery is not fully charged you must charge it for a full eight (8) hour cycle before
attempting to operate your Geo Cruiser for the first time.
Before charging your Geo Cruiser you should be aware of the following:
• Do not leave children unsupervised near the Geo Cruiser while it is charging
• Do not attempt to open the battery housing
Charging your Geo Cruiser
• Power down your Geo Cruiser
• Position the Geo Cruiser close to an electrical outlet.
• Plug the male XLR connector into the female XLR connector located in lower part of the
joystick controller.
• Plug the charger into a wall socket. Red means the power is on and the unit is charging.
Green means the unit is fully charged.
• The average time taken to re-charge batteries will vary from 6 to 8 hours.
Guide to Safe and Lasting Batteries
When the battery voltage is low, the battery charger outputs a larger current to charge. When
battery voltage is close to full, the battery charger outputs a small current. When battery is full,
the battery charger would output very little current which is almost zero. Therefore, the battery
would continually charge after connecting the charger, but does not overcharge. It's better to
charge for no more than eight (8) hours.
Summary of Contents for Geo DX
Page 1: ...Owner s Manual ...
