①CCD front face.(light receiving face of the CCD camera)
Note: 1. Handle the CCD and lens with special care.
2. Always attach the lens cap so as to protect the lens and the CCD from contamination and damage.
3. Dirt, water or oil deposits on either will cause an unclear picture on the monitor, and scratches will
become permanent damage.
②Lens mount(CS mount type)
Note: Any standard model C mount lens can be attached to the GW-107L,if our optional C mount ring,34CMA-R is
fitted to the unit.
③Hexagonal focusing adjustment screws (for fine focusing adjustment by the lens mount ring.)
There are three hexagonal focusing adjustment screws each placed at intervals of 120ﾟaround the lens mount ring
for the forward and backward motion of the lens mount.
④Tripod mounting screw holes (Upper and lower)
Thread size and depth are the same as those for the standard camera tripods.(U1/4")
⑤AUTO IRIS
Female connector for the auto-iris lens.
⑥PHASE ADJUSTMENT VOLUME for the line-lock
A range of 0±120°is available for adjustment.
⑦SHUTTER switch-The electronic shutter speed conversion switch
The electronic shutter function is set to ON upon shipment.
Symbol Shutter mode selection chart
ON
EIA:1/60～1/100000
CCIR:1/50～1/100000
OFF
EIA:1/60
CCIR:1/50
⑧POWER-The power input terminal
For AC24V power supply.
⑨VIDEO OUT-The BNC terminal for video signal output.
NOTE: A 3C2V or 5C2V cable with 75Ω impedance must be used for connection with the GW-107L.
Ｏｐｅｒａｔｉｏｎ：
Note: Ensure that before any connections are made to the GW-107L the power is switched OFF.
1) Remove the Lens Cap from ① the CCD front face and attach the lens.
Note: When the C mount type lens is used, mount the optional 34CMA-R, C mount conversion ring before the lens
is mounted.
: Confirm the specifications of the lens to be used,when it can not be mounted onto the GW-107L smoothly.
(Mounting a nonstandardized lens may cause damage to the threads of the lens and lens mount too.)
2) Using the Auto Iris lens
Connect the iris control cable to AUTO IRIS ⑤ on the GW-107L, when the auto iris lens is used.
IMPORTANT NOTES FOR AUTO IRIS USAGE
: Ensure that the connector mentioned in the operation manual
of the Auto-Iris lens can be applied to the one shown in the
diagram on the right and connect it firmly to the connector on
the right side of the GW-107L.
: Insert the pins as shown in the picture on the right. If the pin
configuration is different from that shown, use the special
adaptor supplied with this unit.
Configuration of the Auto Iris lens
CAUTION: Do not touch the power pin or the signal control pin
connector(on the side of the GW-107L)
with the Common(GND)pins on the extra connector for the Auto Iris lens.
3) Connect the power cables to POWER⑧ on the rear panel of the GW-107L.
NOTE:Ensure that the power is not in the ON position before any connections are made to the GW-107L.
IMPORTANT NOTES FOR POWER ADAPTOR USAGE
: Use a stabilized power supply designed for AC24V±10% with a POWER capacity of 2W.
: Caution:Be careful not to touch any other terminal while wiring.
NOTE:This may cause damage to the GW-107L and power adaptor or may cause fire if the above care and
attention are not adhered to.
