Genuine Scooter Company Buddy 170, Service Manual

Page: 90 / 137

(E)Front wheel
1.Remove the locking nut of the front
wheel on the right side.
2.Draw out the axle of front wheel,
remove the ring and take off the
gear sets of speedometer.
3.Remove the front wheel assy.
4.Assemble the front wheel follows
the opposite procedure of
dismantling.
Locking Torque:
M10: 3.0-4.0kg-m
Note:
1.Put the lock block of speedometer gear assy upon the extrusion of the front fork.
2.Put the grease onto the grease sets of speedometer before assembling.
5.Checking the front wheel axle
a.Check the bending degree of the front axle.
b.Take note of the bending degree on the middle of axle.
c.Limit of use:Change it when above 0.2mm.
86