GENUINE MOTORCYCLES G400C, Owner'S Manual, Page: 31 / 74

29
Pre-ride Inspection
In order to ensure safety, the motorcycle must be checked
before each ride and properly maintained.
Please make sure a thorough inspection of your motorcycle
is completed each time before you ride.
1. Engine oil level check: Insufficient engine oil will cause
premature engine wear and damage.
2. Fuel level check: secure the fuel tank cap and
inspect the fuel hoses for cracks / leaks.
3. Drive chain inspection: a loose chain can fall off of the
sprocket. A severely worn chain may break, insufficient
lubrication can cause chain and sprocket wear, and if the
chain is too tight, then the transmission system will incur extra
burden, which can in turn wear or break the chain.
4. Tire check: Tires with abnormal cuts or deep grooves should
be replaced. The tire tread’s depth should be above the wear
indicator marks. Tire pressure inspection is also crucial.
Improper pressures can lead to tire wear / blow out.
5. Brake system check: Check the brake system for normal
function. Check the condition of the brake fluid level,
pad/shoe wear and brake lines/cables prior to operating the
vehicle. If the level of the brake fluid is lower than the
minimum level line, inspect brake lines for leaks or cracks. If
a fluid leak is found, please do not ride the vehicle and contact
your authorized Genuine dealer for inspection and repair.
6. Cable check: Check if the cable for control is
correctly installed and moves smoothly.
7. Throttle check: Check the throttle grip and throttle cable
to see if there is proper free-play. Determine if the throttle
turns smoothly both opening and closing the throttle.
8. Clutch check: Check the clutch cable free-play and ease of
movement.
9. Lights and horn check: Check if the lights and the horn are
working properly.
10. Rear view mirror check: Sit on the motorcycle and keep
your body vertical to the ground, see if you get a clear view
behind you from the rear view mirrors.
11. Handle bar adjust: Sit vertically on the seat, determine
if the handle bar is at the best position for safe and
comfortable operation. Make sure no cables are tangled.