GENTILIN C 330/50, Instruction Manual

Page: 43 / 198

21
9
9
MOD. CS 240/5+5
7
9
MOD. CS 240/03
MOD. CS240/24 - CS240/50
EN
Rev. 00 - 12/2013 - Cod. CM31710 - Instruction manual
Compressor Mod. CS240
ABNORMALITIES CAUSE SOLUTION
The appliance restarts
numerous times even wi-
thout a utensil.
Leakages from the air pipe,
utensil or pneumatic sy-
stem.
• Check that the pneumatic system is not damaged.
• Check that the air pipe and utensils are intact as well as
the connections.
The utensil does not emit
air.
The tank is not pressurised. • Switch on the appliance and wait until the tank fills che-
cking the pressure of the relevant gauge.
Incorrect regulation of the
outlet pressure.
• Check that the value displayed on the outlet pressure
gauge
(7)
is greater than 0 (zero) bar.
The utensil is damaged. • Check that the utensil is intact and effective.
Fall of pressure in the air
tank.
Leakages in the air pipe,
utensil or the pneumatic
system.
• Check that the pneumatic system is not damaged.
• Check that the air pipe and utensil are not damaged.
• Check that the appliance-air pipe and air pipe-utensil
connections are correct.
• Check that the condensate pump is securely closed
(9)
.
Safety valve intervention.
Pressure switch fault. • Contact an authorised Supplier.
Ai r loss f rom the pressure
switch when appliance
is off.
Unclean or worn return
valve.
• Contact an authorised Supplier.
The appliance vibrates
and/or emits lots of noise.
Mechanical fault. • Contact an authorised Supplier.
Frequent start-ups and
low performance.
Unclean air filters. • Carry out filter cleaning (see Paragraph 31).