•
►
Continue with the other programming steps (see above).
Problems when programming
If you are experiencing problems programming the integrated garage door opener on the rear-
view mirror, take note of the following instructions:
5. This increases the likelihood that garage
door remote control 5 will transmit a strong and precise signal to the integrated garage door
ote control 5 at varying distances and angles from the button you
are programming. Try various angles at a distance between 0 and 8 inches (0 to 20 cm) or at the
me garage door drive is available, repeat the same
programming steps with this remote control. Before you perform the steps, make sure that new
nt of time (the indicator lamp
on the remote control goes out). Press button 6 on remote control again before transmission ends.
reception/transmission.
pening / closing the garage door
egrated garage door opener performs the function of the
garage door system's remote control. Please also read the operating instructions for the garage
martKey to position 2 in the ignition lock.
operate the garage door.
ressed. The
transmission is halted after a maximum of ten seconds and indicator lamp 1 lights up yellow.
to position 2 in the ignition lock.
llow.
- Replace the batteries in garage door remote control
opener in the rear-view mirror.
- When programming, hold rem
same angle but at varying distances.
- If another remote control for the sa
batteries have been installed in the garage door remote control 5.
- Note that some remote controls only transmit for a limited amou
- Extend the antenna cable of the garage door opener unit. This can improve signal
O
After it has been programmed, the int
door system.
•
►
Turn the S
•
►
Press button 2, 3 or 4 which you have programmed to
The transmitter will transmit a signal for as long as the transmitter button is being p
Press button 2, 3, or 4 again if necessary.
Clearing the memory
•
►
Turn the SmartKey
•
►
Press buttons 2 and 4. The indicator lamp lights up ye
HomeLink
and
the
HomeLink
house
are
registered
trademarks
of
Gentex
Corporation.
