Genius SPRINT 05 SW, Instructions For Use Manual, Page: 7 / 14

SPRINT 05 SW
ENGLISH
Guide for the installer
Page 8
1. GENERAL CHARACTERISTICS
We thank you for having chosen one of our products. GENIUS is certain that from it you will obtain all the performance you require. All
our products are the result of years of experience in the field of automated systems, with the added advantage of being part of one of the
sector’s world leading groups.
The SPRINT 05 SW control unit has been designed to control sliding operators with a maximum power of 600W.
The SW models are able to automatically recognise the input voltage with values that range from 95 V~ to 260 V~ (50 / 60 Hz). This
makes it possible to obtain constant output of both the motor and accessories, and therefore extremely smooth operation of the gear train
regardless of any possible sudden changes in voltage that may occur throughout the day.
Thanks to the active and passive safety controls, if correctly installed, it guarantees installation compliant with the safety regulations in
force. The fact that an encoder can also be managed makes it possible to further increase the level of safety.
The extreme simplicity in programming the main functions greatly reduces installation time.
Thanks to the 5 built-in LEDs, it is able to provide the state of the safety devices and limit switches at any given moment.
2. TECHNICAL SPECIFICATIONS
Power voltage 230V~ 50Hz / 115V~ 60Hz
Absorbed power 15 W
Max. load of motor 600 W
Max. load of accessories 500 mA
Operating ambient temperature
-20°C +55°C
Safety fuses 1
Operating logics Automatic, Manual
Open /Close time 120 sec.
Pause time Four pre-set levels
Motor power Adjustable using a trimmer
Terminal board inputs
Open A, Open B, Stop, Limit switch when opening, Limit switch when closing, Photocells,
Power
Terminal board outputs 24 Vdc accessories power, Flashing lamp, Motor, Earthing
Rapid connector Connector for 5-pin receivers, Encoder, Limit switch, Capacitor
Programmable functions
Operating logic, Pause time, Clutch sensitivity, Operation with encoder,
Safety logic, Condo function
Dimensions 145 x 105
3. BOARD LAY-OUT (Fig.1)
CN1 Encoder connector DP1 Parameter setting dip-switch
CN2 Low-voltage terminal board F1 Power/Motor fuses 3.15A T (5x20)
CN3 High- voltage terminal board ALIM Network power present LED
CN4 Receiver connector FSW FSW input state LED
CN5 Limit switch connector STOP STOP input state LED
CN6 Capacitor connector FCA FCA input state LED
TR1 Motor power adjustment trimmer FCC FCC input state LED
4. PREPARATIONS
For safety reasons, it is important for people to carefully follow all the warnings and instructions contained in this booklet.
Incorrect installation or incorrect use of the product can cause serious harm to people.
• Ensure that upstream from the system there is a suitable differential switch, as provided for in current safety regulations, and fit an
omnipolar magnetothermic switch on the power grid.
• Check for the presence of an adequate earthing system.
• For cable installation use adequate rigid and/or flexible tubes.
• Always separate the power cables from the low-voltage control cables. To avoid any interference, we recommend using separate sheathing.
5. CONNECTIONS AND OPERATION
5.1. CONNECTOR CN1
This connector is for use with an encoder. For encoder operation, refer to paragraph 8.
5.2. TERMINAL BOARD CN2 (Fig. 2)