Shooting video
Take out batteries
Operate according to the procedures shown in Figure 6 to remove batteries properly as per
procedures as shown in Figure 6; push to open the battery pack, and remove batteries from the
battery slot.
Charging batteries
You can use the attached charger to charge batteries as per the following procedures.
1) Connect the switch power to the camcorder in the mode as shown in the diagram.
2) Insert the switch power plug into the socket to start charging.
3) Red indicator light flashes to show the charging is under way.
4) LED indicator light will extinguish once charging is completed.
5) Batteries will be fully charged within approximately 180 minutes. Specific charging time may
vary as per battery capacity and local charging conditions
You can also use USB cable to charge batteries in the standby mode. Charge batteries by
following procedures stated as follows. Connect the USB with the camcorder.
1) Connect the USB cable to the USB interface of the computer.
2) Switch off the power to the camcorder to start charging.
3) LED indicator light will extinguish once the charging is completed.
4) Batteries will be fully charged within approximately 180 minutes.
Note:
1) The maximum size of each video file is 3.75GB.
2) The high resolution and high quality will produce the larger file, so the length will be shorter.
3) LCD preview and the proportion for image shooting will vary with the different resolution.
Please refer to:
720P 16:9 screen QVGA 4:3 screen VGA 4:3 screen photograph 4:3 screen
1) Switch on the power supply of the camcorder, and turn the Mode knob to switch to the
Shooting mode;
2) Make use of LCD screen to capture photo images
3) Press the Shooting Start/Stop button to start the recording;
4) Press the Shooting Start/Stop button again to stop the recording;
5) The video clip is automatically saved with a unique file name.
2
