ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
26
Alarm system armed by using the Transmitter.
The alarm system will always be armed by using the transmitter, provided that the ignition
switch is OFF and the system in not in the Valet mode.
To arm the alarm system after leaving the vehicle and closing all the doors, simply press
and let go button I on the transmitter once, the lights will flash once, the siren will sound
once and the LED indicator on the board will start flashing slowly to confirm that the
system in armed. If the electric locks are connected to the alarm system, they will be
locked; the current breaker will be activated avoiding the use of the vehicle, after 3
seconds the system goes to expecting-robbery mode
Exclusion of defective zones
.
When the alarm system is armed and if any of the zones is defective, the siren shall sound
3 times and, simultaneously, the lights will flash 3 times, indicating that a zone is defective,
when this occurs, the defective zone will be automatically excluded and the vehicle will be
protected on the rest of the zones. For example, if the trunk is not closed properly alter
arming the alarm system using the transmitter, the siren will sound 3 times and the lights
will flash 3 times indicating a door is not properly closed and it will exclude the sensors of
that zone. The defective zone will be included again in the protection 3 seconds after
correcting the failure, alter properly closing the trunk.
Armed and activated alarm system
.
When the alarm system is armed, the LED indicator on the board blinks slowly, if a door is
opened, the siren starts sounding and the lights flashing for 60 seconds, if the door
remains open after the 60 seconds, the siren will keep sounding and the lights flashing for
3 minutes, after the 3 minutes, the alarm system excludes the door sensors protecting the
vehicle through the rest of the sensors, if the door is closed before the first 60 seconds
after the siren start sounding, the same will silent after 60 seconds and the light will stop
flashing.
If when the alarm system disarms the siren sounds 4 times and the lights flashes 4 times,
this indicates the vehicle was victim of a carjack attempt. The LED indicator on the board
will continue to blink until the ignition switch is ON. Please check the vehicle.
Alarm System Disarm
When the alarm system is armed, press and let go button No. II on the transmitter, the
siren will sound twice and the lights will flash twice indicating the alarm system disarmed,
the current breaker will deactivate, the LED indicator on the board will turn off, if the
electric locks are connected, they will open, if button II is pressed again, the system will
send the second pulse to open the electric locks
Silent Arm
First press and let go button III and then press and let go button I on the transmitter to arm
the alarm system silently, the alarm system will arm without the sound of the siren. When
the alarm is silently armed and a door is open or not properly closed, the siren will sound 3
times as an alert warning.
Silent Disarm
First press and let go button III and then press and let go button II on the transmitter to
disarm the alarm system silently, the system will disarm without the sound of the siren.
When silently disarmed and after the vehicle has been victim of a carjack attempt, the
siren will sound 3 times as an alert warning.
ARMING WITH ZONES’ CANCELLATION
This system allows us to arm the alarm cancelling the shock sensor as the 1
st
zone and
the shock sensor and doors’ signal as the 2
nd
zone. This is to avoid false alarm when the
shock sensor or the doors’ switch is triggered.
