C
B
P A G E 5
B
G
J
C
N
INSTALL THE SIDE RAILS
Before installing the two
B-Side Guide Rails
, rotate them so that the decorative groove
on the rail and the
C-End Cap / Latches
are positioned as shown in
[9]
. The
C-End
Cap / Latch
must be positioned in this manner in order for the ‘hook’ of the latch to
correctly engage the
A-Screen Cassette Pull Bar
when the screen is extended.
9-A Recess Installation :
Insert both
B-Side Guide Rails
onto the protruding tabs
of the
G-Cassette End Caps [9-A.1]
.
Align the
B-Side Guide Rails
into the final position. Drill 3/16"(5mm) pilot holes at
3"(76mm) in from either end and in the center in between. Attach the
B-Side Guide
Rail
to the door frame using
J-#8 x 3/4”(19mm) Phillips Panhead Screws
. When
installing the
B-Side Guide Rail
, use the
Black Plastic Pile Opener Tool
that is
provided with the screen kit to move the
M-Insect Pile/Weather Strip
out of the
way while screwing the rails to the frame
[9-A.2]
.
9-B Surface Installation :
Using the decorative trim groove as a guide (and staying
to the outside of the glide platforms inside the rail), drill 1/8”(3mm) holes through both
sides of the
B-Side Guide Rail
. Begin by drilling holes approximately 3” (8cm) in from
each end and then evenly space additional holes about every 12” (30cm). Secure the
Guide Rail
to the window with
N-1/8”(3mm) x 1-3/4”(44mm) Alternate Guide Rail
Surface Mount Screws
provided in the bag labeled
Surface Mount Kit
. Do not over
tighten screws.
L
L
A
INSTALLING THE CASSETTE
8-A Recess Installation :
Use
J-#8 x 3/4”(19mm) Phillips Panhead Screws
to
install
K-Recess Mount Clips
to the door frame approx. 4” in from each side.
Snap only the
A-Screen Cassette
into the
Mount Clips
.
8-B Surface Installation :
Position the
A-Screen Cassette
, insert
J-#8 x
3/4”(19mm) Phillips Panhead Screws
into
L-Surface Mount Clips
and
secure
A-Screen Cassette
to the frame.
NOTE: It is critical that the Screen Cassette and Rails be installed square
and plumb in the door opening. Apply shims (not supplied) as needed.
INSTALLATION
8-A
Recess Installation
8-B
Surface Installation
Pile
Opener
9-A.2
Recess Install
9-B
Surface Install
9
End Cap/Latch Position
9-A.1
Side Rail to Cassette End Cap
C A S C A D E
I N S T A L L A T I O N I N S T R U C T I O N S
SCREEN KITS USING 41mm or 42mm CASSETTE