Genie Super-Straddle, Operator'S Manual

Page: 17 / 27

Third Edition • First Printing Operator's Manual
Inspections
Part No. 1298031GT Super-Straddle 15
9 Align the telescoping
base frame in front
of the Genie AWP,
and then insert and
push it into the base
frame.
10 Adjust the Super-Straddle to the desired
length.
11 Insert the straddle
socket retaining
pins (attached to the
straddle sockets at
the front of the
Genie AWP)
through the straddle
length adjustment
holes.
12 Unhook the cords from the storage positions,
and connect the plugs in each of the straddle
sockets.
Function Tests
1 Install a Genie AWP
outrigger at each
corner of the
Super-Straddle.
Adjust the
outriggers to level
the machine and
raise the casters
slightly off the
ground.
Note: The outriggers must be the correct size for
the Genie AWP.
2 Crank the winch and raise the straddle
platform about 1 inch /2.5 cm, enough to allow
the frame retaining pins at each corner of the
Super-Straddle to be inserted into the first set
of holes. Do not raise the straddle platform
past the first set of holes.
3 To insert a frame retaining pin, align the holes
and lift up on the gray tab on the pin retaining
interlock box. The pin is fully inserted when the
gray tab stays up.
4 Insert frame retaining pins at each corner of
the Super-Straddle.
Note: Be sure to use the same hole position for
both pins on one end frame.
5 At the interlock display of the Genie AWP,
insert the key and turn to platform control.
6 Pull out the red Emergency Stop button to the
on position.
Result: The power light and all four outrigger
interlock display lights should come on.