Genie S-60X, Operator'S Manual

Page: 40 / 69

Operator's Manual Second Edition • First Printing
Inspections
38 S-60X Part No. 1261735
Test Limited Drive Speed
47 Press down the foot switch.
48 Raise the boom to just above horizontal.
49 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive
speed with the boom raised should not
exceed 1 ft / 30 cm per second.
50 Lower the boom to the stowed position.
51 Extend the boom 18 inches / 46 cm.
52 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive
speed with the boom extended should not
exceed 1 ft / 30 cm per second.
If the drive speed with the boom raised or
extended exceeds 1 ft / 30 cm per second,
immediately tag and remove the machine from
service.
Test Emergency Controls
53 Shut off the engine.
54 Pull out the red Emergency Stop button to the
on position.
55 Press down the foot switch.
56 Simultaneously hold the emergency power
switch on and activate each function control
handle or toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate
with emergency power.
Test Aircraft Protection Package
(if equipped)
Note: Two people may be required to perform this
test.
57 Move the yellow bumper at the bottom of the
platform 4 inches / 10 cm in any direction.
58 Activate each function control handle or toggle
switch.
Result: No boom and steer functions should
operate.
59 Move and hold the function override switch.
60 Activate each function control handle or toggle
switch.
Result: All boom and steer functions should
operate.