Genie Lift Guard GR-12, Operator'S Manual Supplement

Page: 10 / 22

Operator's Manual Supplement First Edition • First Printing
Installation Instructions
10 Lift Guard™ Contact Alarm Part No. 1293402GT
19 Remove the retaining fasteners securing the
junction box mounting plate to the machine
and set aside.
20 Remove the plug from the junction box and
discard.
ANSI / CSA CE / AS
21 Install the contact alarm harness with the
squeeze connector into the junction box. Set
the coil cord and jumper harness aside. Genie
part number 1293397GT.
22 ANSI / CSA models: Mount the junction box
assembly to the machine using the retaining
fasteners set aside.
CE / AS models: Mount the junction box 5 cm
lower than it's original position on the machine
using the retaining fasteners set aside.
23 Disconnect and remove the platform controller
from the platform. Connect the platform
controller to the C4 connector at the ground
controls.
24 Replace the mast harness assembly from the
ground controls compartment to the platform
junction box.
Note: From the
ground controls, raise
and lower the platform
as needed to route
and secure the
harness. Model Genie part number
GR-12 CE / AS 1293390GT
GR-12 ANSI / CSA 1293394GT
GR-15 CE / AS 1293391GT
GR-15 ANSI / CSA 1293395GT
GR-20 CE / AS 1293392GT
GR-20 ANSI / CSA 1293396GT
GR-12, GR-20 GR-15
1 cable assembly
5 cm
1
1