11
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
C
H
P
ROGRAMMING THE
R
EMOTE
C
ONTROL
Programming 1:
A
To program one Button of a Remote Control (
Figure 11 and 12
):
•
Locate Learn Button and Learn Indicator Light near
Terminal Block on Power Head (
Figure 13
).
•
Press and release Learn Button. Red Learn Indicator Light
will blink 2 times per second.
•
Press Remote Control Button once within 30 seconds.
Red Learn Indicator Light will stay lit.
•
Press Remote Control Button again. Red Learn Indicator
Light will go out, indicating that memory is stored.
•
Press again to Activate Unit.
B
Program each additional Remote using step
A
above.
A
CCESSORIES
To Erase All Remotes from Power Head Memory
A
Press and hold Learn Button on Power Head for 10 seconds or
until Learn Indicator Light goes out. Memory is erased:
•
Program Remotes again as needed.
To Replace Remote Control Battery
A
Push in on Battery Cover Latch at base of Remote Control.
•
Use coin, pen, screwdriver or any similar device.
–
Cover snaps open.
•
Replace old Battery with new compatable coin
type battery.
B
Snap Battery Cover closed.
Remote Control Operation
A
Press Button on Remote Control. Garage door will move.
B
Press Button again. Garage door will stop:
•
The door automatically stops at the end of the open or
close cycle.
C
Press Button again. Garage door will reverse.
WARNING
A moving garage door may cause serious injury or death.
•
Keep people clear of opening while door is moving.
•
Do not
allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
•
Close the door and disconnect the Opener using the
Emergency Release Cord.
•
Do not
use the door Opener, Remote Controls, or
Wireless Keypad.
•
Refer to the door and door Opener Owner’s Manuals
before attempting any repairs.
Figure 13
Learn Code Button and Indicator Light.
(Located Lower Right Corner).
3
4
5
6
MORE
FORCE
LOCATED
UNDER THE
LIGHT LENS
LEARN
INDICATOR
LIGHT
LEARN
CODE
BUTTON
1 Button Compact Remote
w/Docking Station
Figure 11
Genie Remote Controls
3 Button Compact Remote
w/Docking Station
Frequency
Switch
Frequency Switch
Figure 12
Genie Remote Controls
1 Button
Remote
w/Flashlight
3 Button
Large
Remote
w/Flashlight
3 Button
Remote
w/Flashlight
Flashlight Button
Frequency Switch
Remote Control Operation Continued
D
Some Remote Controls are equipped
with a flashlight. The Genie logo is
the button which operates the light.
There is a backlight under the
button. When it does not light, it
indicates the battery
needs replaced.
315 Mhz
390 Mhz
