13
Optional Programming
4
CLEARING MEMORY FOR REMOTES
If the memory has been cleared, the Remote will not activate the door
opener.
NOTE:
The garage door opener will operate normally using the Wall
Console.
NOTE:
When the remote is pressed the round LED will flash blue but
will not activate the door opener.
NOTE:
Clearing Remotes from the Powerhead memory will clear ALL
programmed Remotes and wireless Keypads. Your opener will no
longer recognize any signal received from a missing Remote.
All remaining (or recovered) Remotes and wireless Keypads MUST BE
reprogrammed as shown on pages 9 and 12.
(continued next page)
PROGRAM
SET
PROGRAM
SET
–
+
HOLD
2 seconds
HOLD
2 seconds
1
Press the
Program Set button
on the Powerhead
and hold 2 seconds, round LED comes ON.
PROGRAM
SET
–
+
2
Release the
Program Set button
, round LED goes
off and the long LED flashes purple.
PROGRAM
SET
PROGRAM
SET
–
+
HOLD
HOLD
3
Press
up arrow button (+) and down arrow
button (-)
simultaneously on the Powerhead and
hold until both LEDs flash blue and then go OFF.
4
To verify that the memory is cleared, press
a remote button that was previously
programmed to the Powerhead.