SY-SIX-RDM2-DIN-485 | Synergis IX DIN Rail 2 Door Expander | Installation Manual
Last Updated September 2018
9
Mounting
The Reader Expander is designed to mount on standard DIN Rail either in dedicated DIN cabinets or generic
DIN Rail mounting strip.
When installing the Reader Expander ensure that there is adequate clearance around all sides of the device
and that air flow to the vents of the unit is not restricted. It is recommended to install the Reader Expander in a
location that will facilitate easy access for wiring. It is also recommended that the Reader Expander is installed
in electrical rooms, communication equipment rooms, closets or in an accessible area of the ceiling.
1. Hook the lower tabs under the bottom edge of the DIN Rail.
2. Push the Reader Expander against the DIN Rail mount until the upper tab clips over the upper rail.
Removal
The Reader Expander can be removed from the DIN Rail mount using the following steps:
1. Insert a flat blade screwdriver into the hole in the tab at the top of the Reader Expander.
2. Lever the tab up and rotate the unit off the DIN Rail mount.
