Genesis resource pro, Owner'S Manual

Page: 56 / 72

56
WARNING: If damage or corrosion is found in the Battery Compartment,
return your Resource Pro to an Authorized Genesis Scuba Dealer, and DO
NOT attempt to use it until it has received factory prescribed service.
Battery Installation
• Slide a new 3 volt type CR2450 Lithium Battery, negative (-) side down into the Battery
Cavity. Slide it in from the right side and ensure that it slides under the contact clip on
the left rim of the cavity (Fig. 47).
• Orient the Retaining Bar across the lower portion of the Battery and carefully push it down
into position (Fig. 48).
Battery Hatch and Hatch Retaining Ring Installation
• Replace the Hatch O-ring with a new one. This O-ring must be a genuine Genesis Scuba
part that can be purchased from an Authorized Genesis Scuba Dealer. Use of any other
O-ring will void the warranty.
• Lightly lubricate the new Hatch O-ring with silicone grease and place it on the inner rim
of the Battery Hatch. Ensure that it is evenly seated.
• Slide the Hatch Retaining Ring, top portion first (small opening), onto your thumb (Fig.
49).
• Carefully place the Battery Hatch (with O-ring) into position on the rim of the Battery
Compartment, then press it evenly and completely down into place with your same thumb.
• Maintain the Battery Hatch securely in place and, using your other hand, slide the Retain-
ing Ring down off your thumb and into position around the Battery Compartment.
Fig. 47 - Battery Insertion
Fig. 48 - Retaining Bar
Fig. 49 - Retaining Ring