RJ45/Standard Ethernet connections
GigaBit Ethernet Switch
NAS
Figure 11.22:
GEN DAQ with iSCSI NAS connected through an Ethernet switch
1
Connect the equipment
l
Connect the PC to the Ethernet switch via a standard RJ45 Ethernet
connection.
l
Connect the GEN DAQ to the Ethernet switch via a standard RJ45
Ethernet connection.
l
Connect the NAS to the Ethernet switch via a standard RJ45 Ethernet
connection.
Please read "Connecting the GEN series to a network" on page 88 for GEN
DAQ setup.
At this stage, make sure that all connections and configurations are
correct.
After the GEN DAQ has been configured, the NAS should be configured.
To configure the NAS, use the manufacturer's guidelines. For an example
of further Synology
®
configuration, please refer to appendix “Setting up
the iSCSI using Synology
®
NAS” on page 934. If you have a Synology
®
system, follow the steps in the appendix.
Note
All IP addresses are best set to fixed IP to avoid changing IP addresses when
a system performs a power cycle.
2
Setup in Perception:
Start Perception and navigate to the
Settings
menu via the
Settings
tab
and select
External Storage Setup
.
GEN3t
186
I3995-3.1 en HBM: public