Genesis B2C/Teapot, Technical Manual

Page: 130 / 210

To refill the system, proceed as follows:
1. Remove the drain tube from the boiler drain and replace the blanking plug.
Refit the air intake blanking plug. Refit both the top and lower covers to
the machine. Ensure all fixing screws are re-tightened.
2. Refit the fresh coffee beans container into the machine and open the
outlet slide. Refit ingredient canisters into the machine, rotating outlets to
their correct operating position. Refit the brewer waste bucket into the
machine.
3. Insert the door switch safety key. The machine will initialise, priming the
system with 13.5 fl. oz. (400ml) of water before returning to standby. Hold
a suitable container under the dispense head during machine power up.
Once in standby mode remove the safety key and close the door.
12.6 CoEx® Brewer/Bean Grinder Maintenance (B2C
Machines)
Espresso machines are fitted with the unique CoEx® brewer unit which produces
both fresh coffee and espresso based drinks from ground beans and freshbrew pre-
ground coffee from the same unit. Routine cleaning and maintenance instructions for
this unit can be found in the Genesis Operators Manual - Part No. PR10350001.
12.6.1 CoEx® Brewer/Grinder Blades - 50,000 Vend Service
Crane Merchandising Systems recommends that the brewer unit and bean
grinder is serviced by an authorised engineer after every 50,000 vends.
A CoEx® service kit (part no. PH10820000,
shown opposite) is available from the
manufacturer and contains all of the
components required to ensure the machine
continues to give trouble-free service.
The service kit contains the following
components (with part nos.):
1. Lower piston and cylinder assembly - Pt.
No. ME10592000
2. Filter head assembly - Pt. No.
ME10284000
3. Grinder blades - Pt. No. ME07308000
4. ‘O’ ring - water inlet (not shown) - Pt.
No. ME10595000
1
2
3
Technical Manual
128