(1) Connect the Micro USB plug of the power adapter to the camera, and
the other side to the power outlet, it should be connect the power
adapter to the 110-220V AC outlet.
(2) When the power is connected, the camera will automatically turn on
and the blue indicator will light (the night mode will automatically turn
off).
2.2 Camera Power Switch
(1) Power on, when the power is connected and the power is off, short
press the power switch key
to turn on.
(2) Shutdown, long press the power switch key
for 3 seconds, you can
shut down.
2.3 Handheld Display Power Switch
(1) Charging for the handheld display. The process from no power to full
charge is approximately 2-3 hours, but the machine can be turned on
after the display terminal is plugged in.
(2) Long press power switch key
for 3 seconds to turn on, open the
receiving antenna of the handheld display.
2.4 Watching The Image of Camera
When both the camera and the handheld display are normally turned on,
the handheld device should display the image from the camera(If the
display is not displayed properly, please check the pairing condition.)
(1) If the pairing is not successful, please pairing refer to the 2.5 pairing
instructions;
(2) If the camera you pair is camera1
，
you need to press the switch
button
to switch to camera 1
,then it can be show the image.
If the camera you pair is camera2
，
you need to press the switch
button
to switch to camera 2
, then it can be show the image.
2.5 Pairing
(1) Pair code: When the camera is turned on, press the power button
(about 10 seconds) until the blue light flashes quickly, release the
button, it will enter the code mode. At the same time, open the
handheld display and press
button to turn on the menu. Press
or
to select
and press
to confirm. In the pop-up bar,
continue to press
button to select
and press
to confirm,
and then press
or
to choose
or
for pairing. At this
time, the red light in the upper left corner of the display will flashes,
when pairing successful, the light of camera and display will stop
