GENERALTOUCH TECHNOLOGY CO., LTD
Issued by: Customer Service Department 10
/
22 Issued Date: 2013.10.14
发行部门：客户服务部
发行时间：
2013.10.14
(The close-up view after sticking the touch screen
，贴上触摸屏后的特写视图
)
3. Assemble the controller
安装控制器
1) The mounting location of the controller is usually selected near the exit of the touch screen cable on
the chassis of LCD panel or the back cover of touch monitor. It is necessary to keep the touch screen
cable and the controller at some distances from the power board, A/D board and inverter board, which
aims to avoid the interference from those boards.
控制器的安装位置通常选择在靠近屏线出口的液晶显示面板铁盘或者触摸显示器后盖上。有必要将控制
器和屏线与电源板、高压板和
AD
板之间保持一定的距离，目的是防止这些电路板带来的干扰。
2) Please add at least 2 screws with stages onto the chassis or back cover which are used to fasten the
two mounting holes on the diagonal of the controller. Meanwhile make sure that, after the assembly,
the controller will not touch the chassis in case of short circuit.
请在铁盘或后盖上增加至少两个螺柱，用来固定控制器对角线上的两个安装孔。同时确保安装后，控制
器不会接触到铁盘，避免发生短路。
3) Assemble the controller onto those screws as shown below in the red circle.
将控制器安装在螺柱上，如下图中红圈所示。
Touch Screen Cable’s Exit
屏线出口
