REMOTE TEMPERATURE SENSOR
Remote Temperature
Proposed operating range with alkaline
batteries:
-4.0º to 158ºF (-20.0º to 70.0ºC)
Proposed operating range with lithium
batteries:
-38.0º to 158ºF (-38.8º to 70.0ºC)
Temperature resolution: 0.2ºF (0.1ºC)
Low battery indicator
RF transmission frequency: 433 MH
Maximum number of remote sensors:
3 (1 included)
RF transmission range:
maximum 100 feet (30 meters)
Temperature transmission cycle:
approximately 45 seconds
POWER
Main unit: 2 “AA” batteries (not included)
Remote sensor: 2 “AA” batteries (not included)
Remote rain gauge: 2 “AA” batteries
(not included)
Dimensions
Main unit: 2.75(L) x 5.43(H) x 1.02(D) inches
Remote sensor: 2.37(L) x 4(H) x 1(D) inch
Remote rain gauge:
6.49(L) x 6.89(H) x 4.72(D) inches
FCC STATEMENT
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
Warning:
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user’s authority
to operate the equipment.
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the
equipment and receiver
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced
radio/TV technician for help
RGR150 manual-FINAL-091908:Layout 1 9/19/08 8:59 AM Page 11
