MAXIMUM AND MINIMUM
TEMPERATURE
The maximum and minimum record of the
indoor and remote temperatures will be
automatically stored in the memory of the
main unit.
To display the minimum, maximum or the
current reading press MEMORY button on the
back panel.
To clear the memory, press and hold MEMORY
button on the back for two seconds and all
previously stored readings will be erased.
LOST COMMUNICATION
• If the main unit display line for the remote
temperature sensor reading goes blank,
press and hold the back DOWN (
▼
) button
for 2 seconds to begin a new signal
search. If the signal still isn’t received,
please make sure that:
• The remote temperature sensor is in its
proper location.
• The distance between main unit and
remote temperature sensor is not over
100 feet (30 meters).
• The path between units is clear of
obstacles. Shorten the distance if
necessary.
• Fresh batteries are installed correctly in
both remote temperature sensor and
main unit.
• If there is no reception, please perform
the following steps:
• Bring the main unit and remote
temperature sensor close together.
• Remove four (4) small screws from the
back of the remote temperature sensor
with small Phillips screwdriver, and open
the battery compartment.
• Remove the batteries from the battery
compartment and reinstall them in the
same manner. Remote sensor LED
indicator will flash showing transmission
of the signal.
• Remove the batteries from the main unit
and reinstall them in the same manner.
• The remote temperature appeared on the
main unit’s display will show that
transmission is being received
successfully.
• If the main unit display line for the remote
rain gauge reading goes blank, press
and hold the front DOWN (
▼
) button for
2 seconds to begin a new signal search.
• If the signal still isn’t received, please
make sure that:
• The remote rain gauge is in its proper
location.
• The distance between main unit and
remote rain gauge is not over 100 feet
(30 meters).
• The path between units is clear of
obstacles. Shorten the distance if
necessary.
• Fresh batteries are installed correctly in
both remote rain gauge and main unit.
TRANSMISSION COLLISION
Signals from the other household devices such
as wireless doorbells, home security systems,
and entry control, may interfere with this
product or cause temporary reception
interruption. This is normal and will not affect
the general performance of the product. The
transmission and reception of the remote
readings will resume once the interference
subsides.
LANGUAGE, TEMPERATURE,
CALENDAR AND
CLOCK DISPLAY MODES
Date is displayed in month-date or date-month
format. Each press of the MODE button on the
back panel will toggle the clock modes
between the time with seconds, time with the
day, time zone and a calendar.
MANUAL SETTINGS
REAR PANEL
• Press and hold MODE button for
3 seconds: the 2 digit language letters
will flash.
• If you go into “zone” setting, press mode
2 times to get to day/month display, then
hold “mode” button for 3 seconds to
access “language” setting (1st mode).
RGR150 manual-FINAL-091908:Layout 1 9/19/08 8:59 AM Page 8
