ATTACHING THE MIRRORED VIEWING TIP (OPTIONAL)
The only accessory included with the P18HPART is a 70° mirrored viewing tip.
To attach it to the probe:
1. Pull off the red rubber lens cap (Fig. 1, Callout 6).
2. Unscrew and remove the black metal thread
protector ring (Callout 5), as shown at right.
3. Turn the stainless steel accessory alignment ring
(Callout 4) clockwise to move it away from the
probe tip. Keep turning until the ring can travel
no further.
4. Screw the mirrored viewing tip onto the camera
head (Callout 3) by turning it clockwise, as shown
at right. Keep turning until the viewing tip is as far
from the probe tip as possible. In this position, it
can rotate freely.
5. Press the
button to activate the two-side facing LEDs.
6. Slowly turn the mirrored viewing tip counterclockwise to move it toward
the probe tip. Once the threads of the tip grip the camera head, continue
turning only until the two LEDs are clearly visible through the gap in the
tip’s housing.
7. Secure the tip with the thumb and forefinger of one hand and use your
other hand to turn the alignment ring clockwise. Keep turning the ring until
its leading edge contacts the mirrored viewing tip, locking it in place. The
pair of figures below illustrate the incorrect (left) and correct (right)
orientation of the mirror with respect to the LEDs.
Remove the blue circular protective film from the mirror by pulling on its tab
with a tweezers.
8
✓
