Refering to the diagram above, place hex. head bolts and where applicable lock washers and nuts to assemble
the rear rail to the back of the saw.
ATTACH THE BACK FENCE RAIL TO YOUR SAW
Proceed to fence installation and alignment as per the instructions provided in your “F42” fence manual.
INSTALL AND ALIGN THE FENCE
11
Y
REMOVE / INSTALL A SAW BLADE
BE SURE THE SAW IS UNPLUGGED AND COMPLETELY DISCONNECTED FROM THE POWER SOURCE WHENEVER INSTALLING OR
REMOVING A SAW BLADE!
NOTE
This saw is intended for use with 10" (254 mm) diameter or less saw blades having a center hole diameter of
5/8". There are many types of blades available to perform specific cutting jobs, such as crosscuts or ripping
only, or for use with plywood, panelling and other products. A good quality specialty blade can produce a
finer finish, be more efficient and place less strain on the saw. Use only saw blades designed for use at a maxi-
mum operating speed of 6000 RPM or less. Saw blades should be kept clean and sharp. Never store saw
blades by stacking them directly in contact with each other. Place a layer of cardboard or similar material
between the blades to keep them from coming into contact with each other.
REMOVE A SAW BLADE
2.
Holding the arbor with the arbor wrench provided
, wedge a block of wood between the teeth in
front of the saw and pull the arbor wrench toward
you or counter clockwise
.
1.
Remove the table insert
.