ASSEMBLY INSTRUCTIONS
For your convenience this saw is shipped from the factory partially assembled and requires only minimal assembly
and set up before being put into service. The left and right table extension wings are factory installed and aligned
and unless seriously shaken or jolted in transport should not require further alignment.
If purchased with the standard General “T” Fence System, a full installation and operating instructions manual for
the fence system is supplied in the box with the “F-42” fence.
If purchased with the table board extension and support legs (Millennium Edition only) or if adding an aftermarket
table board and legs, installation instructions can also be found in the “F-42” fence manual.
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COMPLE-
TED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED TO DO
SO.
Refering to the diagram above, place 4 flat head countersunk screws, lock washers and nuts to assemble the front
rail to the front of the saw. But don’t tighten the nuts yet.
NOTE: The front rail, is the wider of the two rails and has holes in both faces.
ATTACH THE FRONT FENCE RAIL TO YOUR SAW
Place the supplied L-jig on top of the table
. Adjust the rail height until the bottom of the jig is flush with the rail shelf.
Hold the nuts firm with a 7/16" wrench and tighten the two screws on left and right ends of the rail. Tighten the center
screws only after double-checking rail height using the L-jig all along the rail and at both ends.
ADJUST THE FRONT RAIL HEIGHT
10
INSTALL AND ADJUST RAILS AND FENCE