General Music WK4, Owner'S Manual, Page: 140 / 376

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
6•28 User Guide
SAVE SINGLE SOUND
Use «Save Single Sound» to save single Ram-
Sounds as well as RAM
-Sounds to disk or hard
disk to build a library of Sounds for future use.
The «Save Single Sound» procedure is charac-
terized by an increased number of steps, owing
to the fact that there are 16 Sound Groups, each
consisting of 8 Banks of 16 slots.
You can choose to save your Ram-Sounds any-
where you want, but it is recommended that you
save to the same location as the original RAM
position to facilitate future selection.
1. Select SINGLE SOUND from the main Save page
and press ENTER to gain access to the FILE SE-
LECTOR.
2. Select the destination device.
Press soft button F1 to select the Floppy disk.
Press soft button F2 to select the Hard disk.
3. Select the destination Block and press ENTER to
gain access.
If necessary, select an empty location to cre-
ate a new Block using the method already
discussed in the General Save procedure.
4. Select the Sound from the RAM directory and its
destination in disk.
To select the destination, use the but-
tons to scroll through the Sound Groups (1,
2, … 15, 16).
Use the directional / arrows to scroll the
individual Sounds of each Bank (1-1, 1-2, 1-
3 … 1-15, 1-16, 2-1, 2-2, … 15-16, 16-1, 16-
2, … 16-15, 16-16).
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Note: You can also use the Sound Search
function to pass directly to a particular Sound and
sound Bank. Refer to the Edit Disk chapter in the
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Reference Guide.
1
ENTER TEMP
ESCAPE
4
3
ENTER TE
ESCAPE
F2
F1
F2
F1
2