MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
18
ADJUSTING THE UPPER BLADE GUIDES
1.
Loosen the two thumbscrews
A
.
2.
Adjust the guides by turning the knurled nut
B
so
that the guides are at least 1/32” behind the teeth
of the blade to avoid damage during cutting. Re-
tighten the thumbscrews
A.
A
A
B
1/32"
B
ADJUSTING THE LOWER BLADE GUIDES
1.
Loosen the set screws
C
located on each side of the
blade guides using a 3 mm Allen key.
Note: To access the lower guide assembly, unlock and tilt
the table.
2.
Adjust the guides by turning the knurled nut
D
so
that the guides are at least 1/32” behind the teeth
of the blade to avoid damage during cutting. Re-
tighten the set screws
C.
1/32"
D
ADJUSTING THE UPPER THRUST BEARING
1.
Loosen the set screws
E
using a 3 mm Allen key.
2.
Then manually adjust the thrust bearing bracket
F
in
or out until the bearing is 1/64” behind the blade
G
.
Retighten the set screw
E.
E
E
C
D
C
1/64"
F
G
REAR VIEW
REAR VIEW
RIGHT VIEW
Summary of Contents for 90-120
Page 25: ...DIAGRAM BANDSAW 25...
Page 29: ...NOTES...
